◆ SpookStack

Approved For Release 2000/08/11 : CIA-RDP96-00792R000300390001-2 LN1i90-91 taping equipment from all angles, ensuring their individual characteristics formed during heating. The information totalled together forms one of a kind samples. It would be impossible to copy these samples. In addition, prior to the experiment, the subject had no contact with the test samples and had no ideal of the form or coding of the target objects. The test subject only came in contact with the samples at the experiment site. Therefore, first, copy of samples was impossible, so switching of containers became meaningless. Second, the glass bottles could not be broken. Third, the samples could not leave the testing site, and there was always someone watching the testing site, ane at i i j i : raphing of the tests. Keb agent Reh tah’ 48 fap ng on ign Beep unber and toding of tablets or plexiglass pieces on the experiment table exactly matched those in the sample bottles. This allows us to only reach one conclusion: that the tablets and pieces of plexiglass were passed through the walls of the container. Also, in the experiment with the sample six bottles, there was only a one mm small hole in one end of the glass bottle and the shielded wire in the bottle was one mm in diameter. This type of one mm shielded wire has many frays at the end (shielded wire is formed from braiding fine metal wires). Even if we used our hand to directly pinch this end of the wire so it would go through a hole the same size, it would be a difficult task. However, this wire was placed inside a glass tube, and there was a 7 mm iron washer there as well. Without breaking the glass bottle, three to five sections were removed and the washer appeared on the outside. The shielded wire on the inside was broken and there were several sections of sections of wire three to ten mm long and the washer was gone. Without a doubt this proves that the shielded wire and the washer passed through the wal] of the container to the outside of the container. However, the glass was not broken. Therefore, it cold only have been a type of paranormal ability that caused to be outside the glass. We should explain that this type of experiment had a high degree of one of a kind. Because of the thickness and length of the samples, the method of securing the wire inside, and the closing of both ends al had their own special characteristics that would be difficult to duplicate. Furthermore, the samples were very long and it would be difficult to switch them undetected. In addition, there were videotaping procedures, ensuring the strictness of the experiments. 2. CONCERNING THE POINT OF BREAKING THROUGH In these experiments, we can see fairly clearly the phenomenon of the target objects passing through the walls of the container. This phenomenon tells us: A. The breaking through point cannot be a hole in the container, a slit in the container or the edges of the seal but is directly through the wall of the container. In the experiments with clear glass containers and relatively smal] target objects, we can also see them become larger during the process of the target objects passing through. Also, in the experiments where the container and the transparent target object were all relatively large, we could 56 Approved For Release 2000/08/11 : CIA-RDP96-00792R000300390001-2